Intergraph StudioZ GT, Руководство по установке, Страница: 69 / 88

59
Set Supervisor Password
This selection controls access to the BIOS Setup utility. Press the
ENTER
key to display the
Supervisor Password submenu. Type the password, and press the
ENTER
key. Retype the
password and press the
ENTER
key again. The password may be disabled by setting the new
password to nothing (pressing the
ENTER
key without first typing a password).
WARNING If you forget the Supervisor Password, it cannot be disabled without clearing
the CMOS.
Set User Password
This setting controls access to the BIOS Setup utility. Follow the same procedure used to set the
Supervisor Password.
NOTE When a password is entered, it is saved immediately. All other changes may still be
discarded (see “Exit Screen” in this chapter).
Password on Boot
When this setting is enabled, the system requires a password upon starting up. Either the
Supervisor or User Password may be entered. The default setting is Disabled.
Exit Screen
When you are finished configuring the BIOS, use the arrow keys to highlight the Exit option on the
BIOS Setup main menu. The Exit screen displays.
Choose one of the following exit options. To move between the Exit options, use the up and down
arrow keys (
↑
and
↓
):
Entry Description
Exit Saving Changes
Saves the changes you have made, exits the BIOS, and restarts the
system to make these changes take effect.
Exit Discarding Changes
Leaves the previous BIOS settings intact, exits the BIOS, and
restarts the system.
Load Setup Defaults
Returns the BIOS parameters to their original default settings.
Discard Changes
Discards any changes you have made, but does not exit the BIOS.
Save Changes
Saves any changes you have made, but does not exit the BIOS.
To save your changes and restart the computer, choose Exit Saving Changes.