Intergraph StudioZ GT, Руководство по установке, Страница: 13 / 88

3
Observing Safety Precautions
WARNING Follow all instructions explicitly to avoid personal injury and equipment
damage.
Before installing the base unit into a rack, prevent the rack from moving by engaging the
stabilizers. If the rack is not equipped with stabilizers, refer to the documentation delivered with
the rack for stabilizing instructions.
Observe the following safety precautions when installing the base unit into a rack or when using
the rack-mounted system:
♦
Extend only one slide rail set at a time. Push an extended slide rail set back into the rack
before extending another.
WARNING Extending more than one slide rail set could cause the rack to fall forward,
causing damage to the equipment and injuring anyone in front of the rack.
♦
Do not push on or lean against the rack. Always engage the stabilizers. The adjustable feet
should be lowered securely against the floor.
♦
If the rack contains an AC distribution box or an uninterruptible power supply (UPS), do not
connect the power cord to the wall outlet until instructed to do so in the system
documentation.
♦
Set up the system completely before you start it.
WARNING Once you install equipment into the rack, do not move the rack with equipment
installed or powered on, or damage to internal components may result. If you
must move the rack, first shut down the system and turn off system power,
remove all equipment, and then move the rack.
Placing the System Components
Refer to the documentation delivered with the rack for instructions to unpack it and set it up.
When placing system components, keep these guidelines in mind:
♦
Move and place the monitor and the base unit carefully.
♦
Place the base unit in a well-ventilated location where air can circulate freely around it.
♦
Do not expose the system to high levels of dust, smoke, or moisture.
♦
Maintain the following operating environment:
−
Temperature range: 50
°
F to 77
°
F (10
°
C to 25
°
C). Optimum: 70
°
F (21
°
C)
−
Humidity range: 20 % to 80 % non-condensing. Optimum: 50 %