Intel SR1600UR - Server System - 0 MB RAM, Руководство по обслуживанию

Страница: 87 / 190

Intel
®
Server System SR1600UR Service Guide 69
Installing and Removing the I/O Expansion Module
Installing the I/O Expansion Module
To install the I/O expansion module, follow these steps:
1. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” on page 41 .
2. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” on page 46 .
3. Squeeze the sides of the I/O expansion module filler panel(s) to disengage it from
the server system back panel and remove it (see letter “A” in Figure 59 ).
Note: If you are installing an I/O expansion module that uses only one slot, remove the filler
panel only from the slot shown so that the module can be attached to I/O connector 1. Do
not remove the filler panel from the second slot.
4. Attach the standoffs to the server board by pressing into the holes (see letter “B” in
Figure 59 ).
Note: For the 1-socket expansion module, install the three standoffs shown in gray. For the 2-
socket expansion module, also install the fourth standoff shown in red..
5. Position the I/O expansion module over the server board as shown in Figure 59 .
6. First fit the front of the module into the back panel slot(s), and then attach the
module to the server board connector and engage the standoffs (see letter “C” in
Figure 59 ).