Intel 8XC251SA, Руководство пользователя

Страница: 96 / 458

8XC251SA, SB, SP, SQ USER’S MANUAL
5-14
5.5.2 Conditional Jumps
The MCS 251 architecture supports bit-conditional jumps, compare-conditional jumps, and
jumps based on the value of the accumulator. A bit-conditional jump is based on the state of a bit.
In a compare-conditional jump, the jump is based on a comparison of two operands. All condi-
tional jumps are relative, and the target address (rel) must be in the current 256-byte block of
code. The instruction set includes three kinds of bit-conditional jumps:
•
JB (Jump on Bit): Jump if the bit is set.
•
JNB (Jump on Not Bit): Jump if the bit is clear.
•
JBC (Jump on Bit then Clear it): Jump if the bit is set; then clear it.
Section 5.4.1, “Bit Addressing,” describes the bit addressing used in these instructions.
Compare-conditional jumps test a condition resulting from a compare (CMP) instruction that is
assumed to precede the jump instruction. The jump instruction examines the PSW and PSW1 reg-
isters and interprets their flags as though they were set or cleared by a compare (CMP) instruction.
Actually, the state of each flag is determined by the last instruction that could have affected that
flag.
The condition flags are used to test one of the following six relations between the operands:
•
equal (=), not equal (
≠
)
•
greater than (>), less than (<)
•
greater than or equal (
≥
), less than or equal (
≤
)
For each relation there are two instructions, one for signed operands and one for unsigned oper-
ands (Table 5-9).
Table 5-9. Compare-conditional Jump Instructions
Operand
Type
Relation
= ≠ >
<
≥ ≤
Unsigned
JE JNE
JG JL JGE JLE
Signed JSG JSL JSGE JSLE