46 |
P a g e
Emulsion tank over‐temperature switch
The emulsion tank over‐temperature switch (Figure 25) is attached to the
tank next to the thermostat temperature sensor. It is a backup that turns
off tank heat in case of thermostat failure.
To adjust the switch, loosen the ring, turn the dial to the desired
temperature setting, and tighten the ring.
Avoid Damage:
Always set the emulsion tank over‐
temperature switch below the boiling point of the emulsion.
Figure 25:
Emulsion tank over‐temperature switch.
Temperature gauge
The temperature gauge is mounted near the heating elements.
Содержание Spray Paver
Страница 10: ...15 P a g e Figure 1 Safety decal location may vary depending upon model x2 x2 X2...
Страница 22: ...41 P a g e Figure 21 Solenoid valve manifold in its enclosure...
Страница 58: ...Integral dx 121 N 1st Street Montevideo MN 56265 USA T 320 269 3227 www integraldx com sales integraldx com...
