Integra DTR-40.4, Инструкция по эксплуатации

Страница: 31 / 104

Turning On & Basic Operations
En-31
Tuning into Radio Stations
■
Auto tuning mode
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by entering
the appropriate frequency.
Presetting AM/FM Stations
You can store a combination of up to 40 of your favorite
AM/FM radio stations as presets.
■
Selecting Presets
■
Deleting Presets
1
Press Tuning Mode so that the AUTO indicator
lights on the AV receiver’s display.
2
Press Tuning
q
/
w
.
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
1
Press Tuning Mode so that the AUTO indicator
goes off on the AV receiver’s display.
2
Press and hold Tuning q / w .
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
TUNED
FM STEREO
AUTO
1
On the remote controller, press Tuner repeatedly
to select “AM” or “FM”, followed by D.TUN .
(Actual display depends on the country.)
2
Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8 , 7 , 5 or 8 ,
7 , 5 , 0 .
If you have entered the wrong number, you can retry
after 8 seconds.
1
Tune into the AM/FM station that you want to store
as a preset.
See the previous section.
2
Press Memory .
The preset number flashes.
(Actual display depends on the country.)
3 While the preset number is flashing (about 8
seconds), use
Preset
e
/
r
to select a preset from 1
through 40.
4 Press Memory again to store the station or channel.
The station or channel is stored and the preset number
stops flashing.
Repeat this procedure for all of your favorite AM/FM
radio stations.
1
To select a preset, use
Preset e
/
r
on the AV
receiver, or the remote controller’s
CH +/–
.
Tip
• You can also use the remote controller’s number buttons to
select a preset directly.
1
Select the preset that you want to delete.
See the previous section.
2
While holding down Memory , press Tuning Mode .
The preset is deleted and its number disappears from
the AV receiver’s display.