2
ezeio
Controller and the 2400-A16 input expansion Manual Index.
Product Liability.
Page 2
Description.
Page 3
Ordering Information.
Page 3
ezeio Controller Compatibility.
Page 3
Section 1 - ezeio Controller.
Page 4
Configuring the ezeio Controller local inputs.
Page 4
Getting started with configuration.
Page 4
Easy steps for Calibration.
Page 5
Section 2 - 2400-A16.
Page 7
Intech Micro 2400-A16 Station
Page 7
Adding a 2400-A16 station to an ezeio Controller.
Page 7
Getting started with configuration.
Page 8
Configuring the ezeio Controller.
Page 9
Example 1: eze temperature input scaling for RTD’s and thermocouples.
Page 10
Example 2: For all other analogue values the 2400-A16 outputs to eze...
Page 11
Example 2.1: Analogue Flow meter.
Page 11
Example 2.2: Analogue Pressure sensor.
Page 12
Example 2.3: Digital Flow Meter.
Page 13
Example 2.4: State On/Off.
Page 14
On Site Calibration Trim.
Page 14
Section 3 - Alarms.
Page 15
Using a data GSM/3G SIM in the ezeio-GSM Controller.
Page 16
Product Liability.
This information describes our products. It does not constitute guaranteed properties and is not intended to affirm the suitability of a
product for a particular application. Due to on-going research and development, designs, specifications, and documentation are subject to change
without notification. Regrettably, omissions and exceptions cannot be completely ruled out. No liability will be accepted for errors, omissions or
amendments to this specification. Technical data are always specified by their average values and are based on Standard Calibration Units at 25C,
unless otherwise specified. Each product is subject to the ‘Conditions of Sale’.
Warning: These products are not designed for use in, and should not be used for patient connected applications. In any critical installation
an independent fail-safe back-up system must always be implemented.
Note: The eze System uses US English, so some spelling/terminology differs.
ezeio™ is a trademark of
eze System, Inc.
