10
Next, click on ‘System’.
Set the ‘Modbus speed’ (i.e. Baud rate) to the same as
that of the 2400-A16 (as shown). It is recommended to
also tick the ‘Use slow polling’ box.
Note: Not all the options are shown.
Next task is to add the 2400-A16 inputs onto the
ezeio
Controller:
Click on ‘Inputs’ and then click on ‘Add input’.
Example 1:
eze
temperature input scaling for RTD’s and thermocouples.
Select ‘Custom’ for all 2400-A16 input configurations.
Type in these 2 calibration details for all listed temperature probes, both RTD
and Thermocouple.
The 2400-A16 sends the exact temperature to the
ezeio
Controller.
Chose a ‘Logging’ time.
Note: Failure to select a Logging time will result in this input not being
viewable on
eze
.
In this case, the Ambient Temperature Probe is wired in the 2400-A16, input 1.
Important!
eze System inputs cannot be re-ordered, so the
initial setup is critical
!
