FOR USE BY QUALIFIED PERSONNEL ONLY
Belt Tension
1.
Locate the two bolts on the front and the side of each
rail enclosure. These bolts control the belt tension.
2.
To adjust belt tension, first slightly loose the side bolt
until it is free to move. Do not take the bolt out of its
seat.
3.
Next, turn the front bolt using an Allen wrench to
adjust the belt tension.
4.
Turn clockwise to tighten the belt and
counterclockwise to relax.
5.
Once adjustment is made, tighten the side bolt.
Pressure Setting
1.
Locate the air regulator assembly on the left side of the
machine.
2.
Pull the air regulator knob up.
3.
Turn the air regulator knob clockwise to increase
pressure, or counterclockwise to decrease pressure.
4.
The pressure setting is displayed on the pressure gauge.
5.
When the operating pressure is set, push the air
regulator knob down until it locks.
Motor Speed Setting
The motor speed control panel is located at the rear of the
machine. Use the
On/Off
switch to turn on the motor.
1.
Use the speed control
knob
to adjust the motor speed.
An increase motor speed means a faster platen travel.
NOTE
The suggested operating pressure ranges
between 75
– 85 psi.
Low pressure setting may result in poor
printing and longer cycle times.
Do not operate the machine at more then
100 psi.
Machine Setting
Upper Platen Teflon Sheet*
1.
Remove both side panels.
2.
Locate the four (4) screws that are used to increase
or decrease the slack of the upper platen Teflon
cover.
3.
Turning clockwise makes the sheet tighter and vice
versa.
*not available on all models
7
