FOR USE BY QUALIFIED PERSONNEL ONLY
Auto Start- Repeat (Fully Auto Mode, continuous cycle)
1.
If the machine is at the
Manua
l mode, make sure both
work stations are in their full stop positions on both
ends. Use
Up Plate
or
Bottom Plate
button to move
them to their full stop positions if needed.
2.
Select
Auto Start
button to
Once
. The button shall be
in the up position.
3.
Turn the
Auto/Manual
switch to
Auto
.
4.
Select the
Auto Start
button to
Repeat
. The button
shall be in the down position. The auto cycle starts
immediately.
5.
If the machine is at the
Semi Auto
mode, select the
Auto Start
button to
Repeat
. The auto cycle starts
immediately.
6.
To come out of the Auto Start- Repeat Mode, do any
of the followings:
a.
Turn Auto/Manual to
Manual
b.
Select Auto Start to
Once
c.
Use Emergency Stop buttons
Machine Operation Mode
Auto Start Mode Operations
Auto Start- Once (Semi Auto Mode, one cycle at a time)
1.
Turn
ON/OFF
switch to
ON
position.
2.
Select the
Auto Start
button to
Once
. The button
shall be in the up position.
3.
Turn the
Auto/Manual
switch to
Auto
. The two
Start
buttons at the front console are now activated.
4.
Press the two (2)
Start
buttons on the console to start
one (1) press cycle. The external work station will
shuttle into the chamber while the other station is
coming out simultaneously. The heat press then starts
automatically. When the press cycle is complete, the
work station is lowered and stays inside the chamber.
Press the two
Start
buttons again to repeat the press
cycle.
CAUTION
Keep hands clear of gaps when the machine
is in operation. See Pg. 4 for Machine Safety.
NOTE
In the situation of an emergency, press the
Emergency Stop buttons on the front console
of the machine.
NOTE
The shuttle trays must fully retract before
Auto Mode can be activate. If the trays is not
fully retracted put the machine back to
Manual mode. Then fully feed either the top
or button tray into position. Restart Auto Start
Process.
11
