FOR USE BY QUALIFIED PERSONNEL ONLY
6.
Press the
Manual Start
button to activate the pistons
and raise the work station. The timer then starts its
countdown and beeps 3 seconds before completion.
7.
After the press is complete, the work station is
automatically lowered. Press/hold either
Up Plate
or
Bottom Plate
button to retrieve the work station in
ready position.
Machine Operation Mode
Make sure the machine is properly installed before use. The machine will not operate without air
pressure and correct power source (3 Phase + Ground). Make sure the electric motor is turned on.
Manual Mode Operation
1.
Turn
ON/OFF
switch to
ON
position.
2.
Turn the
Auto/Manual
switch to
Manual
. When in
Manual
mode, the two green start buttons in the front
console are de-activated.
3.
Allow the machine to warm up to the set temperature.
A buzzer will sound when the temperature reaches to
the set temperature. The buzzer will continue until a
press cycle is initiated.
4.
Place the substrate on the working station and smooth
out all wrinkles.
5.
Press either the
Up Plate
or the
Bottom Plate
button
to feed the external work station into the heat press
chamber. Press and hold the button until the moving
work station has completely stopped.
NOTE:
Heating may take anywhere from 45
– 60
minutes depending on the set temperature.
Do not leave the machine unattended at
anytime.
CAUTION
Keep hands clear of gaps when the machine
is in operation. See Pg. 4 for Machine Safety.
Note
:
During the press cycle, you may hear sounds
of springs compressing. This is normal since
the upper platen is attached with springs that
produce a squeaking sound when they are
compressed.
10