‑5‑
Fundamental Safety Instructions
Fundamental Safety Instructions
Safety Precautions
1. This chapter presents essential safety instructions for a proper use of the
equipment. Before operating the equipment, read through the user guide and
comprehend all the safety instructions. Failure to comply with the safety
instructions may result in death, severe personal injuries, or equipment damage.
2. "CAUTION", "WARNING", and "DANGER" items in the user guide only indicate some
of the precautions that need to be followed; they just supplement the safety
precautions.
3. Use this equipment according to the designated environment requirements.
Damage caused by improper use is not covered by warranty.
4. Inovance shall take no responsibility for any personal injuries or property damage
caused by improper use.
Safety Levels and Definitions
Indicates that failure to comply with the notice will result in death
or severe personal injuries.
Indicates that failure to comply with the notice may result in death
or severe personal injuries.
Indicates that failure to comply with the notice may result in minor
or moderate personal injuries or equipment damage.
General Safety Instructions
●
Drawings in the user guide are sometimes shown without covers or protective
guards. Remember to install the covers or protective guards as specified first, and
then perform operations in accordance with the instructions.
●
The drawings in the user guide are shown for illustration only and may be different
from the product you purchased.
Unpacking
●
Do not install the equipment if you find damage, rust, or signs of use on the equipment
or accessories upon unpacking.
●
Do not install the equipment if you find water seepage or missing or damaged
components upon unpacking.
●
Do not install the equipment if you find the packing list does not conform to the
equipment you received.
Содержание SV660P Series
