Innovative BV20, Руководство по эксплуатации

Страница: 37 / 48

Copyright Innovative Technology GA794-2
APPENDIX D – CONFIGURATION CARDS
Instructions for use
1) Select correct width card for bezel. Cut
card around outline – check
measurements as printed. Check print
options ‘Page scaling’ is set to ‘none’
when printing a pdf file to ensure correct
size.
2) Fill in sections as required. Take care
to fill in the selections correctly, keep
inside the lines and fill boxes fully as
example below.
3) Power up BV20 and allow it to reset.
4) Click ‘function’ button on BV to
access Configuration Mode, BV bezel
LEDs should be flashing at 1 second
intervals.
5) Enter card into BV in direction
indicated by arrows.
6) Card will be returned and if
configuration was good the bezel LEDs
will flash rapidly while programming
takes place. TAKE CARE TO ENSURE THE
POWER IS NOT REMOVED AT THIS
STAGE, THE BV MAY SUFFER
PERMANENT DAMAGE!! The BV will
then reset.
If an error occurs has occurred the card
will be rejected and the bezel LEDs will
flash slowly a number of times to
indicate the cause of the error. (see
table below)
Flash Error Codes
2 – Invalid card read – card entered
wrong way round, card mis-read or card
wrong version
3 – No interface selection was detected
on card
4 – Multiple interface selections
detected
5 – Invalid interface selected – the
selected interface is not available for
this BV
6 – Selected interface not compatable
with BV version
7 - Pulse configutration error. Selected
pulse options invalid.
8 – ccTalk configuratrion error. Selected
cctalk options invalid (cctalk 8 bit chk
not allowed without ccTalk Plain)
9 – Low power mode not available on
this BV version
IMPORTANT CHECK THAT THE CONFIGURATION REQUESTED HAS BEEN SET IN THE BV20 BEFORE USE .
NV200 Operations Manual 31
BV20 Operations Manual 37