Innovative BV20, Руководство по эксплуатации

Страница: 17 / 48

Copyright Innovative Technology Ltd 2008 GA794-2
5.3 BINARY OUTPUT – BIN
To use Binary mode The Binary interface must be programmed into the validator via the
Configuration Cards (See Appendix D – Configuration Cards) or via the ITL BNV Currency
Manager program.
In Binary mode, the BV20 will issue a binary pattern on vend lines 1 to 4 as shown in Table
9 – Binary Credit Outputs. A maximum of 15 channels can be used.
Vend 1 Vend 2 Vend 3 Vend 4 Credit Channel
LOW HIGH HIGH HIGH Channel 1
HIGH LOW HIGH HIGH Channel 2
LOW LOW HIGH HIGH Channel 3
HIGH HIGH LOW HIGH Channel 4
LOW HIGH LOW HIGH Channel 5
HIGH LOW LOW HIGH Channel 6
LOW LOW LOW HIGH Channel 7
HIGH HIGH HIGH LOW Channel 8
LOW HIGH HIGH LOW Channel 9
HIGH LOW HIGH LOW Channel 10
LOW LOW HIGH LOW Channel11
HIGH HIGH LOW LOW Channel 12
LOW HIGH LOW LOW Channel 13
HIGH LOW LOW LOW Channel 14
LOW LOW LOW LOW Channel 15
Table 9 – Binary Credit Outputs
Connections:
Connections in Binary mode are the same as for Parallel mode.
Note: Channels higher than four cannot be individually inhibited, but will be globally
inhibited if inhibits 1 to 4 are inhibited.
It is possible to operate the BV20 in Low power mode with the Binary interface. For further
details please see Chapter 5.4.
5.4 LOW POWER OPTION
Notes:
•
Low Power Mode can ONLY be used with the above Parallel, Pulse and Binary
protocols.
•
Low power mode can only be enabled by correctly completing the configuration
cards or via the ITL BNV Currency Manager Program.
•
In Low Power Mode the front sensor is checked every 1 second which can lead to
a delay in accepting the note when it is presented.
Configuration button functions are only available during power up before the BV20 goes
into Low Power Mode.
BV20 Operations Manual 17
BV20 Operations Manual 18