Innova 3120d, Руководство пользователя, Страница: 89 / 131

Ford OBD1 Systems
ADDITIONAL TESTS FOR EEC-IV SYSTEMS - WIGGLE TEST
3120d 87
7. A "One moment please test is in
progress" message shows temporarily
on the Diagnostic Tool’s LCD display.
„
If the Diagnostic Tool fails to link to
the vehicle's computer, a "Vehicle is
not responding" message shows on
the Diagnostic Tool's LCD display.
Do the following:
For KOEO Wiggle Test:
- Verify the ignition is ON.
- Turn the ignition OFF, wait 10 seconds, then turn back ON to
reset the computer. Press the ENTER
button to continue.
For KOER Wiggle Test:
- Turn the engine OFF, wait 10 seconds, then turn back ON.
Press the ENTER
button to continue.
BE SURE to perform the added procedures in step 6, if
appropriate for your vehicle, BEFORE turning the ignition ON.
- Press ENTER
button to
continue.
„
If the Diagnostic Tool cannot link to
the vehicle’s computer after three
attempts, the message “Contact
Technical Support” displays.
- Press the M button to return to
the Ford OBD1 menu.
- Turn the ignition OFF, and dis-
connect the Diagnostic Tool.
- Contact Technical Support for
assistance.
8. If the Diagnostic Tool was able to link to
the vehicle successfully, a "Wiggle test
is active..." message shows temporarily
on the Diagnostic Tool’s LCD display.
This is followed by a message instruct-
ing you how to perform the test.
„ Press the M button if you wish to
exit the Wiggle Test at this time.
9. Wiggle, tap and move the suspected
sensor or wiring.
„
If no faults are detected when
performing the Wiggle Test, a
"System Pass" message displays.