Innova 3120d, Руководство пользователя, Страница: 66 / 131

Chrysler/Jeep OBD1 Systems
ERASING DTCs
64 3120d
„
If you do not want to proceed, use the UP and DOWN
buttons, as necessary, to highlight NO, then press the ENTER
button to cancel the erase procedure.
4. If you chose to erase DTCs, a status
screen displays while the erase function
is in progress.
„
If the erase was successful, a con-
firmation message shows on the
Diagnostic Tool’s LCD display.
Press the ENTER
button to exit.
Due to the differences in computer
systems, the Diagnostic Tool can
be used to erase codes for some
vehicles, while others require
codes to be erased manually. If
the “To erase DTC’s consult the
vehicle’s service repair manual...”
screen displays, you must consult
the vehicle’s service repair manual
for procedures to erase DTCs.
„ If the erase was not successful, an
advisory message shows on the LCD
display. Verify that the Diagnostic Tool
is properly connected to the vehicle's
DLC and that the ignition is ON. If the
erase process still does not complete,
turn the ignition OFF, wait 10 seconds,
then turn back ON and repeat steps 2
and 3.
„ If the erase process fails after three
attempts, the message “Contact
Technical Support” displays.
- Press the M button to return to
the Chrysler OBD1 Menu.
- Turn the ignition off, and
disconnect the Diagnostic Tool.
- Contact Technical Support for
assistance.
Erasing DTCs does not fix the problem(s) that caused the
code(s) to be set. If proper repairs to correct the problem that
caused the code(s) to be set are not made, the code(s) will
appear again and the check engine light will illuminate as soon
as the problem that cause the DTC to set manifests itself.