Innova 3120d, Руководство пользователя, Страница: 111 / 131

Additional Tests
SPECIAL TEST MENU
3120d 109
The Diagnostic Tool does not perform non-continuous test, but
retrieves results from the most recently performed tests from
the on-board computer’s memory. You may retrieve non-
continuous test results for only one test at any given time.
1. From the "Special Test Menu", use the
UP
and DOWN buttons, as
necessary, to highlight Non-
Continuous Test, then press the
ENTER
button.
2. A “One moment please. . .” message
displays while the request is sent to the
vehicle’s on-board computer.
„ The “Select Test” screen displays.
The screen shows all tests
applicable to the vehicle under test.
Refer to the vehicle’s service repair
manual for information related to
non-continuous tests.
If non-continuous tests are not
supported by the vehicle under test,
an advisory message shows on the
Diagnostic Tool's display. Press the
M button to return to the Mode
Selection menu.
3. Use the UP and DOWN buttons,
as necessary, to highlight the desired
test, then press the ENTER
button.
4. When test results have been retrieved,
data for the selected test will show on
the Diagnostic Tool’s display. The
display shows the following information:
„ Test ID number
„ Module ID number
„ Component ID number
„ Min or Max test limit
Only one test limit, either Min or Max, is shown for any
given test.
„
Test Value and status
Status is calculated by the Diagnostic Tool by comparing the
Test Value against the displayed test limit (either Min or Max).
Status is shown as either Low, High or OK.
5. Press the M button to return to the “Select Test” screen. When you
have finished viewing the retrieved test data, press the M button to
return to the Main Menu.