Innova 3120d, Руководство пользователя, Страница: 106 / 131

Toyota/Lexus OBD1 Systems
CODE RETRIEVAL PROCEDURE
104 3120d
„ If the Diagnostic Tool fails to link to the vehicle’s computer a
“Vehicle is not responding” message shows on the Diagnostic
Tool’s LCD display. Do the following:
- Verify the ignition is ON.
- Check the cable connections at
the Diagnostic Tool and at the
vehicle’s DLC.
- Turn the ignition OFF, wait 10-12
seconds, then turn back ON to
reset the computer.
- Press the ENTER button and
repeat steps 3 and 4 as
necessary.
„ If the Diagnostic Tool cannot link to
the vehicle’s computer after three
attempts, the message “Contact
Technical Support” displays.
- Press the M button to return to
the Toyota OBD1 menu.
- Turn the ignition off and discon-
nect the Diagnostic Tool.
- Contact Technical Support for
assistance.
8. If the Diagnostic Tool was able to link to
the vehicle successfully a "Code retrieval
was successful..." message shows
temporarily on the Diagnostic Tool’s LCD
display followed by any retrieved DTCs.
„ The Diagnostic Tool will display a
code only if codes are present in the
vehicle's computer memory. If no
codes are present, a "No DTC' are
presently stored in the vehicle's
computer" message is displayed.
9. If more than one code was retrieved
press the DTC button, as necessary, to
display additional codes one at a time.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information. Use the
button, to view the additional information.
10. Disconnect the Diagnostic Tool from the vehicle and turn the ignition
key OFF.