INIM Electronics SmartLine Series, Инструкция по установке и программированию

Страница: 10 / 72

10 General information
Conventional fire detection control panel
Note:
The detached notes contain important information about the text.
Attention:
The attention prompts indicate that total or partial disregard of the procedure could damage
the connected devices.
Danger:
The danger warnings indicate that total or partial disregard of the procedure could injure the
operator or persons in the vicinity.
2.11 Menu paths
Example
From panel:
<key>, Programming, Progr. zone , select a zone, Ok
Via software application: Control panel, Zones
Access to specific functions can be achieved by using the panel keys or PC video objects and the respective path.
Note:
This manual describes the recommended programming flow.
Attention:
For most part this manual describes programming from the control panel.
2.12 CE Mark
Figure 2 - Certifications for SmartLine control panels
Note:
The indications for the CE marking shown in the installation manual of the SmartLetLoose/ONE electronic
board (optional accessory device) are an integral part of the indications shown here on condition that it is
installed in the mentioned control panels.
Declarations of performance, declarations of compliance and certificates relating to the products mentioned
in this manual can be downloaded from the following website:
www.inim.biz
0051
EN 54-2:1997 + A1:2006
EN 54-4:1997 + A1:2002 + A2:2006
EN 54-21:2006
SmartLine020-2
Control and indicating equipment with integrated power supply
equipment and alarm transmission and fault warning routing
equipment for fire detection and fire alarm systems installed in
buildings
INIM ELECTRONICS S.R.L.
via Dei Lavoratori 10 - fraz. Centobuchi
63076 Monteprandone (AP) - Italy
18
0051-CPR-1414
0051
EN 54-2:1997 + A1:2006
EN 54-4:1997 + A1:2002 + A2:2006
EN 54-21:2006
SmartLine036-4
Control and indicating equipment with integrated power supply
equipment and alarm transmission and fault warning routing
equipment for fire detection and fire alarm systems installed in
buildings
INIM ELECTRONICS S.R.L.
via Dei Lavoratori 10 - fraz. Centobuchi
63076 Monteprandone (AP) - Italy
18
0051-CPR-1412
0051
EN 54-2:1997 + A1:2006
EN 54-4:1997 + A1:2002 + A2:2006
EN 54-21:2006
SmartLine020-4
Control and indicating equipment with integrated power supply
equipment and alarm transmission and fault warning routing
equipment for fire detection and fire alarm systems installed in
buildings
INIM ELECTRONICS S.R.L.
via Dei Lavoratori 10 - fraz. Centobuchi
63076 Monteprandone (AP) - Italy
18
0051-CPR-1413
Essential characteristics Performance
S S A P Performance under fire conditions
S S A P Performance of power supply
Response delay (response time to fire) PASS
S S A P Performance of transmission
S S A P Operational reliability
Durability of operational
reliability:
temperature resistance PASS
vibration resistance PASS
S S A P electrical stability
humidity resistance PASS
Options provided according to EN 54-2 Performance
7.8 Output to the fire alarm device PASS
7.9 Control of fire alarm routing equipment PASS
S S A P e t i c s u e l l e d o d r a t i R 1 1 . 7
7.12 Dependencies on more than one signal (Type A and B) PASS
S S A P Test condition 0 1
Essential characteristics Performance
S S A P Performance under fire conditions
S S A P Performance of power supply
Response delay (response time to fire) PASS
S S A P Performance of transmission
S S A P Operational reliability
Durability of operational
reliability:
temperature resistance PASS
vibration resistance PASS
S S A P electrical stability
humidity resistance PASS
Options provided according to EN 54-2 Performance
7.8 Output to the fire alarm device PASS
7.9 Control of fire alarm routing equipment PASS
S S A P e t i c s u e l l e d o d r a t i R 1 1 . 7
7.12 Dependencies on more than one signal (Type A and B) PASS
S S A P Test condition 0 1
Essential characteristics Performance
S S A P Performance under fire conditions
S S A P Performance of power supply
Response delay (response time to fire) PASS
S S A P Performance of transmission
S S A P Operational reliability
Durability of operational
reliability:
temperature resistance PASS
vibration resistance PASS
S S A P electrical stability
humidity resistance PASS
Options provided according to EN 54-2 Performance
7.8 Output to the fire alarm device PASS
7.9 Control of fire alarm routing equipment PASS
S S A P e t i c s u e l l e d o d r a t i R 1 1 . 7
7.12 Dependencies on more than one signal (Type A and B) PASS
S S A P Test condition 0 1