INHECO DWP, Руководство пользователя, Страница: 20 / 37

INHECO 19
Doc ID: 900434-001
March 2018
4.4.
Adress Switch
A six-pole DIP-Switch can be found at the back side.
Fig.12: Rear side of Incubator showing the Address-Switch
Only the switches 1 to 4 are used for setting the address. These switches are for
identification, if more than one single-device or stack is connected to the PC with USB.
The default address is “2”. The recognition of the device/stack depends on the switches
position as shown in figure 13.
Fig.13: Address-Switch
4.5.
Connecting devices
4.5.1.
Stackable devices and multiple towers
INHECO’s compact single position Incubators are high performance plug & play
devices for the use on automated robotic platforms or as standalone units. They can
either be used as single devices or stacked in a tower. In addition multiple towers or
single devices can be controlled parallel from one host PC via USB. The combination of
different devices of the Incubator family in one tower is possible.
Fig.14: Example of stacked devices
Two devices are operated with one power supply and controlled via one USB interface,
the 15-pole SUB-D-Connectors on the back side are used for connecting the devices.
The following chapter shows, how the devices have to be connected. → Technical Data
for maximum allowed numbers of instruments, page 11.