Infranor XtrapulsEasy 60VDC, Руководство по установке

Страница: 27 / 33

27
XtrapulsEasy
™-DB - Installation Guide
Chapter 5 - Appendix
5.1.2.6 - X10A connectors
PHOENIX n°1989874 connectors
Direct connection to wire with AWG between 20 and 24
PIN FUNCTION I/O DESCRIPTION
1 RS232 TX O Transmit data RS-232
3 RS232 RX I Receive data RS-232
2 CAN H IO Line CAN-H (dominant high)
4 CAN L IO Line CAN-L (dominant low)
12 +24V I 24V
DC
supply: +/- 15%
Consumption: 300mA without digital output loads
17 GND
6 GND
14 GND
30 GND
8 OUT1 O "high side" logic outputs 24V / 500mA
10 OUT2 O
19 IN1 I All logic inputs are referenced to GND
Vin voltage = 18V < Vin < 27V
Input impedance Zin = 10k
Ω
21 IN2 I
23 IN3 I
25 IN4 I
15 +5V O Encoder supply voltage (max. current = 300mA)
26 R1 (ref) O Resolver signal
24 R2 (reference -) O Resolver signal
16 S3 ()
Encoder A/ I Resolver signal / Encoder signal
18 S1 (cosine -)
Encoder A I Resolver signal / Encoder Signal
20 S2 (sine +)
Encoder B/ I Resolver signal / Encoder Signal
22 S4 (sine -)
Encoder B I Resolver signal / Encoder Signal
29 I Analog input nr. 1
Differential input +/-10V *
27 IN_ANA1- I
28 TM+ I Motor thermal sensor input. The valid measurement
range is between
100
Ω and 44 kΩ measured between TM+ and GND
9 HALL_U I Hall sensor input signal phase U
11 HALL_V I Hall sensor input signal phase V
13 HALL_W I Hall sensor input signal phase W
7 Encoder Z I
5 Encoder Z/ I
5.1.3 - Jumper configuration of the capacitor bus
Three jumpers allow the user choosing the bus capacitor value between 470µF and 1880µF.
These jumpers are J2,J3, J4. See chapter 5.1.1 for their location.
The following table gives the capacitor value according to the jumper configuration.
Capacitor value Jumper config.
470µF NO Jumpers
940µF 1 jumper SET
1410µF 2 jumpers SET
1880µF J2 J3 J4 SET