Inficon ULTRATEST UL3000 Fab, Перевод оригинальной инструкции по эксплуатации

Страница: 119 / 140

INFICON Accessories and interfaces | 10
UL3000-Fab-Operating-instructions-iina73en1-08-(1910) 119 / 140
10.2.3 Configure digital inputs
These inputs can be used to operate the device with a programmable logic controller
(PLC).
The digital inputs PLC-IN 1 ... The available functions can be assigned in any way
necessary to the 10 I/O module.
– Active signal: typically 24 V
– Inactive signal: typically 0 V.
The 24V output of the I/O module can be used as an active signal.
Every function can be inverted.
ü
Supervisor - rights
1
> Setup > Accessories > I/O module > Digital inputs configuration
2
Select as desired "Digital input".
ð
The inputs PLC-IN 1 - 10 are available.
3
Select the desired Function, see the table below.
4
Select the desired Mode.
ð
The modes "Standard" or the mode "Inverse" are available for selection.
To mode "Inverse": In the following table overview, the arrow pointing the
transfer direction in the column "Transition" must be reversed.
5
Save .
Function Transition Description
Vent inactive→ active: Vent inlet (only in standby state)
CAL inactive→ active:
active→ inactive:
Start calibration.
Apply value for background and finish calibration.
No function - The input is not functioning. Recommended setting of unused inputs.
Clear inactive→ active: Erase warning or error message / cancel calibration.
Sniff inactive→ active:
active→ inactive:
Enable sniffer mode.
Enable vacuum mode.
Purge inactive→ active:
active→ inactive:
Switch-on purge (only in standby state)
Switch-off purge (only in standby state)
Start inactive→ active: Change to the measurement mode.
Start/Stop inactive→ active:
active→ inactive:
Change to the measurement mode.
Switch to Standby.
Stop inactive→ active: Switch to Standby.
ZERO inactive→ active:
active→ inactive:
Switch ZERO on.
Switch ZERO off.