Inficon HLD6000, Перевод оригинальной инструкции по эксплуатации

Страница: 40 / 90

6 | Operation INFICON
40 / 90 HLD6000-Operating-instructions-kinb43en1-05-(2107)
6.2.8.6 Configure digital inputs
You can set which function is carried out by a signal on the digital input.
1 > Setup > Interfaces > I/O module > PLC inputs
2 Select one of the 10 PLC inputs and allocate a function to it:
– No function
– CAL extern
– Start
– Stop
– Delete
– Trigger selection (to use this function, switch the "Sniffer button configuration"
to "Off", see “Setting up the sniffer probe [
}
46]“).
3
Choose between "Normal" or "Inverse".
4
Assign additional PLC inputs to a function if necessary.
5
Confirm with .
6.2.8.7 Setting the interface unit
1 > Setup > Interfaces > I/O module > Units
2 Select the unit for the output of leakage rates from the following options:
– g/a (factory setting)
– lb/yr
– mbar l/s
– oz/yr
– Pa m³/s
3 Confirm with .
6.2.9 Bus module
On the USB stick that comes with the HLD6000 and the BM1000 bus module, you will
find further bus module files. This also includes the GSD file for PROFIBUS, which is
located in the “..\Manuals\Interface Description“ folder.
For the different bus modules from INFICON see also “Accessories and spare parts
[ } 80]“.
6.2.9.1 Creating a connection between the device and the bus module
To create the connection between the bus module and the device, do the following:
1 Switch the instrument off.
2 Connect the INFICON Bus module with a data cable to the M12 socket on the
rear of the device, see "Basic unit [
}
13]", Fig. 2.
3
Switch on the HLD6000.