Inficon HLD6000, Перевод оригинальной инструкции по эксплуатации

Страница: 31 / 90

INFICON Installation | 5
HLD6000-Operating-instructions-kinb43en1-05-(2107) 31 / 90
5.3.4 Using an extension hose for a sniffer tip
To get into hard-to-reach areas, attach an extension hose to the sniffer tip, see
"Accessories and spare parts [
}
80]".
Note that you cannot trace CO
2
with an extension hose!
With the extension hose installed, you cannot calibrate with an external CO
2
calibration leak.
Fig. 9: Attach the extension hose
1 Filter holder on the sniffer tip
2 Short extension hose
3 Adapter
4 Release ring
5 Extension hose
If it is necessary to shorten the extension hose, cut off the end of the extension hose
that you use to sniff the test object at an angle of about 45°.
1 To attach the extension hose to the sniffer tip, screw the adapter from the set
with the extension hose to the filter holder at the end of the sniffer tip.
ð
Make sure that the short extension hose at the end of the adapter encloses
the filter holder.
2 Insert the extension hose into the rear opening of the adapter.
ð The extension hose is automatically locked into position.
3 To connect the extension hose to the calibration opening for internal calibration
for the COOL-Check, insert the centering ring into the calibration opening on the
device to make the COOL-Check opening smaller.