50
Attachment
Bolt
SIDE VIEW
UPPER ANCHORAGE FITTINGS
FOR SEDANS ONLY
Anchorage Fittings
For cars not fitted with a child restraint anchorage point
For Sedans Only
Drill a 9mm diameter hole in the parcel shelf on the
centre line of the seating position as shown in
Figure 1C. Hole must be no closer than 200mm
from the front of the back seat. Install the anchor
bolt as shown in Figure 1D.
Note to Queensland purchases: The installation of
anchorage points must be approved by authorised
officers appointed by Queensland Transport.
Authorised officers can be sourced from all
Queensland Transport Customer Service and
Queensland Ambulance Service Centres.
For Vehicles other than Sedans
In Australia, consult your nearest child restraint
fitting station of traffic authority for vehicle inspec-
tion to find the best, correct position for the
placement of the anchorage point, and for the
correct attachment bolt length use of spacers.
In New Zealand consult the agent of the vehicle.
CHILD RESTRAINTS MUST NOT BE
ATTACHED TO UNSOUND METAL OR
WOOD OR SYNTHETIC
STRUCTURES. WHEN DRILLING THE
9MM HOLE DO NOT DRILL
THROUGH FUEL LINES, FUEL
TANKS, ELECTRICAL WIRING OR
RADIO SPEAKERS. WEBBING
STRAPS MUST BE PROTECTED
FROM SHARP CORNERS AND
EDGES.
THE ANCHOR FITTING MUST BE
USED ONLY AS DESCRIBED ABOVE.
IT MUST NOT BE HOOKED ONTO
ANY OTHER OBJECT.
Anchor
Fitting
Spacer(s)
(if required)
Vehicle
Trim
Reinforcing
Washer
Lock
Washer
Nut
FRONT OF VEHICLE
Vehicle
Metal
Structure
WARNINGS
!
