39
Aircraft Use
How to Install into the Aircraft
Fit The Infant Carrier to the Aircraft Seat
The Infant Carrier without base is suitable for use on aircraft. The Infant Carrier must be used
in accordance with the aircraft operators procedures, and any directions from the aircraft
operator, pilot or crew.
The Infant Carrier may not fit in smaller aircraft. Inform the aircraft operator that a child
restraint is intended to be used on the aircraft when booking the flight as the child restraint
may not be suitable for use in that operator’s specific aircraft.
Follow the instructions of the flight crew or pilot.
For use of the child restraint in cars in countries other than Australia and New Zealand,
the user should consult the country’s local authorities, car hire companies, car insurance
companies, etc. for advice. The child restraint may not be acceptable for use in all cars.
You do not need the base and we recommend that
you check it in with your luggage.
Position the infant carrier rearward facing.
If possible, lift the armrests out of the way to improve
access to installing the aircraft lap belt and to suit the
width of the carrier.
Place handle in "carry" position (fully upright).
Fold back the sides of the seat cover to expose the
aircraft seatbelt path.
Infant Seat
Step 1:
Step 2:
Step 3:
Step 4:
AIRCRAFT
SEATBELT PATH
Never use this path in a car
IMPORTANT
!
Ensure that you use the
AIRCRAFT SEATBELT PATH
identified by the following label.
AIRCRAFT
SEATBELT PATH
Never use this path in a car
Fully lengthen lap belt.
Thread the lap belt into
AIRCRAFT
SEATBELT PATH
lap belt path (green marker),
ensuring that lap part is below the hook as shown on
each side (refer Figure 1 & 2).
Figure 2
Figure 1