IndigoVision 9000 Series, Руководство пользователя

Страница: 37 / 68

User Guide - v7 37
► For information about using a 9-22mm lens, see "Using a 9-22mm lens" on page 41
Installing the Environmental Vandal Resistant variant
If installing the camera in temperatures below - 10°C please read the section “Low
Temperature Start-Up” before continuing.
Once you have configured your camera's IP settings, you are ready to install it in its final
position.
The exit collar MUST be used when installing the Environmental Vandal Resistant variant.
There are five stages to installing the Environmental Vandal Resistant variant:
1. Run the cabling to the access point
2. Fit the exit collar to the wall/ceiling
3. Connect the heater power supply
4. Fit the camera to the exit collar
5. Set up the sensor
Run the cabling to the access point
When the wall or ceiling has been prepared, run the required cables up to the cable access
hole.
Fit the Exit Collar
The Exit Collar has cable exit holes on the side and top. Before fitting the Exit Collar, ensure
the exit holes which are not being used are sealed using the blanking plug or grommets
provided.
86.25mm
Dia 163.0mm
13.8mm
27.6mm
Central Point
(cable exit from wall)
86.5mm
12.5mm
28.5mm
86.25mm
Figure 28: Exit Collar wall/ceiling fixing points and access hole
Enhanced SD Fixed Dome - 9000 Range 4 Installation