IndigoVision 9000 Series, Руководство пользователя

Страница: 34 / 68

34 User Guide - v7
86.25mm
Dia 163.0mm
13.8mm
27.6mm
Central Point
(cable exit from wall)
86.5mm
12.5mm
28.5mm
86.25mm
Figure 25: Exit Collar wall/ceiling fixing points and access hole
1. Use the profile template supplied with the camera to mark out the fixing holes and
cable access point on the mounting surface.
2. Prepare the holes and make the cutout on the mounting surface, fitting appropriate
mounting plugs.
3. Remove the rubber plugs from the exit collar fixing holes, then secure the Exit Collar
(9) to the mounting surface.
Ensure you use appropriate screws such as No.10 x 1inch (4.8mm thread by 25mm)
CSK stainless steel screws.
4. Replace the rubber plugs into the Exit Collar fixing holes.
5. Run the cables through the wall/ceiling access hole and through the exit collar cable
entry.
The Exit Collar provides two cabling options:
• A 3/4” NPT or M25 threaded cable exit on the side (8).
The side entry is intended to be used with conduit. It is the installer's responsibility to
ensure a watertight seal is made between the conduit and the exit collar.
• Three access holes on the top.
Each hole is fitted with a rubber grommet. The Ethernet cable provided with the
camera has a compatible grommet.
To ensure a water tight seal, use the Ethernet cable provided with the compatible
grommet. A mini in-line coupler is provided to connect the Ethernet cable to an existing
cable.
To run the cabling through the Exit Holes on the base, follow these steps:
a. Push the cable through the grommet.
b. Ensure you have enough cable pushed through for camera connections.
c. Draw the cable back to invert the center of the grommet and create a water tight
seal.
4 Installation Enhanced SD Fixed Dome - 9000 Range