Copyright © 2018 InCoax Networks AB. All rights reserved.
21
Confidential under NDA
Table 8
— Description of the Coax ports parameters.
Term
Value
[Default Value]
Definition
On/Off
On/Off [On]
On (Green) indicates that the coaxial port is active.
Off (Red) indicates that the coaxial port is inactive.
Power
0 - 10 [10]
This parameter sets the transmit power level when automatic power
control is disabled and sets the max. power level when “Power
Control” is enabled. Each reduction in the index is a 3 dB reduction in
the transmitted power level.
PA/Attenuation
[Off/Off]
Amplified output and/or attenuated input.
MoCA Band
[A - D, 1125 -
1625 MHz]
Choose the frequency range.
RF Channels
[5]
Define the number of 100 MHz Channels to be used for each port.
Beacon frequency
500 - 1600 MHz
depending on MoCA
band [1150]
Frequency used by the
Controller
to broadcast beacon messages.
Primary channel offset
[above]
Centre frequency in the primary channel relative to the beacon
frequency.
Secondary channel
offset
[above]
Centre frequency in the secondary channel relative to the primary
frequency.
First channel offset
[0]
Define start of first channel relative to the primary channel.
Power Control
On/Off [On]
Enable or disable automatic power control. If On the output power is
set up to the configured Power (0 - 10). The benefit with automatic
power control is that the risk of interfering with other analogue
devices is reduced due to overall lower transmit power levels. Power
control is enabled when the checkbox is checked.
Power Control Rate
0 - 2048 Mbps [680]
This parameter is the required physical bit rate that will be targeted in
the automatic power control mode. The max. output power is still
regulated by the
Power
parameter. The default value is 680.
Apply
Click to apply the settings.
Reset
Click to discard the settings.
3.4.4
Service VLAN
A service VLAN is a configuration template for VLANs. A “default VLAN” always exists on the
Controller
. This
VLAN can be edited but it cannot be deleted. The
Controller
can handle up to 200 different 802.1q VLANs.
Hover over
MANAGEMENT
in the main menu and click on
SERVICE VLAN.
All configured VLANs will be displayed. One example is shown in
Figure 22
. Click on the symbol if you want
to delete one of the VLANs.
Figure 22
— Service VLAN.
3.4.4.1
Adding VLAN
Add a new VLAN by clicking on
ADD VLAN
in the Options menu on the right-hand side in
Figure 22
. A web page
will appear as seen in
Figure 23
.
The description of the parameters is found in
Table
9
. Enter the desired
settings and click on the button
ADD VLAN
.
3.4.4.2
Configure Multicast Groups for VLAN
Configure the multicast groups that shall be allowed on the VLAN by clicking on the
MC
symbol in the
SERVICE VLAN
listing of the VLANs. See
Figure 22
. The
MC
configuration page can be seen in
Figure 24
and
the description of the parameters is found in
Table 10
. Click on the button
Update VLAN
to save the settings.
Содержание In:xtnd
Страница 44: ......
Страница 45: ...Copyright 2018 InCoax Networks AB All rights reserved Confidential under NDA ...
