IMET Spa VELOX 350 AF-NC, Инструкция пользователя

Страница: 42 / 73

TRADUCTION OF THE ORIGINAL USER’S INSTRUCTIONS
VELOX 350 +SIRIO 370AF-NC FAST INSTRUCTIONS 12
20 - DRAINING OF USED / PRODUCED SUBSTANCES
Please remember to abide by the current Law Norms concerning the draining of:
- materials used by the machine (for example hydraulic circuit oil, reduction gear oil, oil for installations of lubrication and
so on);
- scrap materials or materials not usable anymore (for example ferrous and not ferrous chips, tools like blades and so on);
- substances used for cleaning and maintenance;
- materials used in some instances of the machine life (for example when packing, shipping and so on).
21 - DEFECTS IDENTIFICATION
The solution of most part of the inconvenients that could happen during the work can be found by consulting this
paragraph.
The first part concerns the machine working and includes a list of the possible defects with respective controls that must
be made; the second part concerns the inconvenients that can be found by checking the blade and / or the cut pieces.
If your problem is not included in in the forseen ones or you need the presence of qualified technicians, please get in
touch with the manufacturer or the reseller by keeping this instruction book .
21.1 - DEFECTS CAUSED BY THE MACHINE
Inconvenients
Check
A* Electric motor does not work (because of the blade) 1-3-4-13-14-15
B* The blade spindle works backwards 1-2
C* The blade does not work 15
D* The motor stops during the working 3-9-13-15-19-20
E* The blade stops easly during the cutting process 16-17-18-19-20
F* The coolant is not sufficient 5-6-7-8
G* The motor heating is high 13-14-15-19-20
H* The reducer heating is high 11-12-15-19-20
I* The blade locks in the workpiece during the cutting 10-16-18-23-24-25
L* The cut is not perpendicular to the worktable 10-11-17-18-20-22-23-25
M* The blade does not work right 11-22-26
N* The workpiece moves or deformes 20-23-24-25
O* The chip is thin or powdered 17-18-19-21
P* The chip is large or burnt 16-17-20
Q* The head does not get down till the cut end 26 27-28
R* There is too much burr on the cut piece 16-17-18-20-29-30
S* The electronical/electric panel does not light on 14-31-36-37-32
T* The head doesn’t go down regularly (autom.cut.models 10-27-33
U* The Automatic Cycle don’t start 34
LIST OF THE PARTS THAT MUST BE CONTROLLED
1 = Plug is right inserted in the socket
2 = The emergency button is pushed
3 = The line fuse (if there is)
4 = Main switch
5 = Tap of the coolant
6 = Chip tray tank too full
7 = Electropump of the coolant
8 = The tank is empty or dirty
9 = Excessive heating that determins the interventation of the thermoprotectors
10 = Excessive gap of the head guides
11 = Reducer bearings demaged or to be regulated
12 = Level of the head oil