IMET Spa VELOX 350 AF-NC, Инструкция пользователя

Страница: 35 / 73

Page
VELOX 350 +SIRIO 370AF-NC FAST INSTRUCTIONS 11
•
Move the advancer carriage towards the blade (forwards) with button (20) and when it has arrived near the base
(completely forward) turn back by about 20 or 30 mm with the button (21).
•
6. Push the button "F1" [ SET ] then "F1" [set-point icon] then "F4" [ axis 1 set-point ] and confirm the axis
zero-adjustment request with start key [ I ] (pos.8). The feeder carriage moves forward slowly and then slowly
backwards to set the visualiser to zero. At the end of the zero-adjustment cycle the menu returns to the starting
page and from there, turn to the first page by pushing the "EXIT" key several times.
•
Holding the key SHIFT(34) pushed, push 2 times the key (28) [+V ] to move the cutting end reference point
completely up and always with key SHIFT(34) pushed, push key (27) [-V ]to completely lower the end cutting
reference point.
•
Move the saw head with buttons (24) and (25) to about 50 mm from the worktable (adjust the speed of this
movement with the descent regulator) and memorise this point as the start cutting value by SETon button (33).
•
Move the arch close to the worktable bench and memorise this point as the end cutting limit , by SHIFT and two
times SETon.
•
Move the arch above the start cutting point (above the indicator to the right of the screen and turn on 0 the speed
regulator of the saw head.
•
The Velox machine has only one blade speed = 3600 RPM (on request 2 speeds 1800 and 3600 RPM), selected
by button (28) [ +V].
•
Correctly position the front vices to avoid collisions with other parts of the machine and from the starting page push
the "F2" button (programs library) to create the first cutting program. Could be somee programs are listed, but: you
•
•
push "F1" to insert a new program,
•
•
key in the length of the piece/pieces to be cut,
•
•
push "Enter", key in the quantity,
•
•
•
push "Enter", key in the length of possible other
pieces to be cut and their quantity
•
•
During this operations you’ll note a little horizontal
line marks the field where you are digiting: you
can move it by using the red arrows and
memorise other parameters as: (this is our
picture, may be on your screen appairs other