IMET Spa VELOX 350 AF-NC, Инструкция пользователя

Страница: 19 / 73

TRADUCTION OF THE ORIGINAL USER’S INSTRUCTIONS
VELOX 350AF-NC ED.2011eng rev.00 19/73
Place the bracket inside the floor stand. For opening the doors you have to loosen the lower hooks indicated in the
picture- pos. 1 - dr. RI0503-. Remove the protective substances placed on the surfaces during the moving and transit by
using cleaned and non-filamentous clorth or paper, and please check that there is no rust on the metallic parts.
In case of using compressed air jet always wear proper eye protection glasses.
Take out the chip tray from the right side of the floor stand and remove the possible objects that can obstruct the passage
of the coolant. The parts in motion (band guides, trolleys, pivots, bearing support, bearing disc etc. ) are already lubricated.
The pneumatic equipment, ready to start, includes an automatic lubricator capable to regulate the quantity of oil put in the
circuit -dr.RI0344-. Then go on as follows:
13.1 - COOLING AND LUBRICATION PLANT
If necessary, by following the instructions of the supplier, prepare the coolant suitable for the cutting material because in
some cases we suggest to cut by dry method, especiallly on thin walled sections, or tubular profiles.
In case fill the tank with the cooling according to the instructions of the supplier of the product. Pour the coolant into the
tank placed inside the base, max 15 liters. It is possible to reach it by front side after opening the right door by the back
side.
If not you can pour it directly between the work table and the base.
In this case keep attention that the removable chip tray and the tank are correctly placed.
13.2 - PNEUMATIC CONNECTION
The machine is supplied with the air treatment unit -dr. RI0344-, but it is right to connect it to a system provided at least
with condensate discharger, with pipes correctly setted, at least with a pressure of 5/6 BAR. The consumption of air is
about .5.Nl max. for each automatic cycle.
The air filter –4/RI0344-has an automatic valve that cleans itself each time the air is connected/disconnected; the
lubricator –3/RI0344- has a little screw in the top –7/RI0344-: by a screwdriver can be adjusted to supply the right quantity
of oil into air ( ab.one oil drop each 10/15 working cycle). To refill it, see OIL & LUBRICANT chart to find the right one.
13.3 - ELECTRICAL CONNECTION