IMET Spa VELOX 350 AF-NC, Инструкция пользователя

Страница: 27 / 73

TRADUCTION OF THE ORIGINAL USER’S INSTRUCTIONS
VELOX 350AF-NC ED.2011eng rev.00 10/73
Calibrating feeder vice must be done under the following
circumstances:
1. When you first receive machine, prior to operating
automatically
2. When the power has been removed from machine,
that is each working day.
3. When you need to run in automatic cycle
To calibrate feeder:
-Make sure material is not clamped in saw vice or feeder
vice, and place feeder vice about 100/200 mm stroke.
-Referring to page one of startup instructions: turn off
power at disconnect, them turn it back again.
-This time, push the cycle start button
(I)
Feeder will automatically move forward to frontmost
position, then automatically return about 30/50 mm
inches from front. It do not shows 0.
Calibration is now automatically done by your
machine.
Setting Feed Vice:
-Push feed vice unclamp button
-Turn frontal screw – 1/RI0347- until it is wide enough
open to insert your material. It is possible to despace the
whole front jaw –4/RI0347- in 3 steep, to ensure greater
capacity. Remember always to fix screws
-Place material in vice , close it by frontal screw and
open again about 1 rotation (4/5 mm).
-Push vice clamp button to clamp material in vise.
If clamping thin tubing and you wish to reduce clamping
pressure, you may now adjust clamping pressure by
regulators placed on the front of the floor stand.
Setting Bar End microswitch
Set the microswitch placed at the infeed side of
machine –pos. 13/RI0503- at the proper heigh ( for
example: in the middle of the material, for round
bars) ; the plastic wheel must be at the material
surface Look at these picture and check if you ear
for a” click” when you keep out the material from
loading roller
Initiating fully automatic operation
-Push F2” (Library of programs)
You will see two or three programs already installed.
You will see two or three programs already installed.
On the above screen, you can see 3 programs. The first
one is 001, the second one is ABC and the third one is
KZO.
Once you are in the library of programs, you can do one
of the following:
F1 - Create a new program
F2 - Delete and existing program
F3 - Delete all programs
F4 - Move to end of list (your list will eventually get quite
long)