Operating manual - English
ECODRILL 2000 C/E
23
7.6
Cutting keys for FICHET
The clamp can also be used to cut keys for FICHET (H profile).
The procedure is as follows:
1) open the clamps slightly by loosening knobs (E) and (E1).
2) place the keys with the stop up against the clamp.
3) secure the keys by tightening knobs (E) and (E1).
Fig. 20
Cutting:
1) After gauging, use the knob (O) to activate the spring for laser keys (cap. 6.4 - central cutting).
2) turn on switch (Q), lower the collet assembly and position on the beginning of the cut.
•
secure the spindle at this height by turning the lever (I) clockwise.
•
carry out the cuts using only lever (C).
Note: the letters in brackets refer to fig.4, page 10.
E
E1
