ECODRILL 2000 C/E
Operating manual - English
14
5
MACHINE INSTALLATION AND PREPARATION
The key-cutting machine can be installed by the purchaser and does not require any special skills.
The machine is supplied ready for use and does not need to be set up, except when changing to different
tools. However, some checks and preparation for use need to be carried out by the operator.
5.1
Checking for damage
The ECODRILL 2000 C/E key-cutting machine is solid and compact and will not normally damage if
transport, unpacking and installation have all been carried out according to instructions.
Notwithstanding, it is always advisable to check that the machine has not suffered any damage.
5.2
Environmental conditions
To ensure that the best use is made of the key-cutting machine, it is important to place it in a well-aired
area which is not too damp:
The ideal conditions for the machine are:
-
temperature between 0 and 40°C
-
relative humidity: approx 60%
5.3
Positioning
Place the machine on a horizontal surface, solid enough to support the weight of (30 Kg). The workbench
should be approx. 100-120 cm high to give easy access to the working parts of the machine.
Leave enough space around the machine (20-30 cm) to ensure good ventilation and room for
manoeuvre.
WARNING:
ensure that the key-cutting machine voltage is suitable for the mains supply available, which
must be earthed and provided with a differential switch.
Fig. 7
5.4
Description of work station
The machine needs only one operator, who has the following controls at his/her disposal:
•
master switch (P) placed on the back of the machine (fig.4, page 10).
•
motor start switch (Q) (on the left-hand side of the machine).
•
tool setting keypad (K).
•
levers:
- lever (C) (fig.4, page 10) to move the clamp carriage.
- lever (I) to move the vertical carriage.
20
0 m
m
200 m
m
200 mm
