Operating manual - English
ECODRILL 2000 C/E
15
6
MACHINE REGULATION AND REGISTRATION
Before carrying out cutting operations is necessary proceed with regulation about:
•
fitting the tools and setting
•
the cross spring for Laser (sidewinder) keys.
6.1
Fitting and regulating the tools
WARNING:
make sure that the motor start switch
(Q)
(fig.4, page 10) is turned off.
Switch on the machine with the master switch.
Select the tools for the key to be cut and proceed as follows:
1) place the tracer point all the way into the left-hand sleeve and secure by tightening the grub screw (M)
(fig.8).
2) place the cutting tool all the way into the right-hand sleeve and secure by tightening the grub screw
(M1).
Releasing the tools
Unscrew the grub screw (M) and (M1) (fig.8) to remove the tracer point and cutting tool from the sleeves.
Fig. 8
6.2
Adjustment
Note: please note that before adjusting the machine you need to eliminate the tracer springing
(chap.6.3, page 16).
For carrying out adjustment, insert the cutter and tracer into their relative mandrils, block the bars (or 2
identical keyblanks) in the clamps and proceed as follows:
1) turn the machine on using the (P) main switch (fig.4, page 10).
2) using the lever (I) lower the cutter-tracer unit so that the tracer touches the pin (fig. 9).
3) switch ON the lever of the front panel.
4) turn the adjustment knob (N) until the cutter touches its relative pin.
5) If both green leds switch ON simultaneously alignment is ok.
6) Switch off the lever.
7) the machine is adjusted and ready to duplicate.
Fig. 9
M
M1
N
U
