iKarus Opticc 6 Sport, Инструкция по эксплуатации

Страница: 59 / 99

Optic 6 Sport - Page 10
On-Off Switch
Optic 6 Sport Programming Switches and Buttons
SAFETY NOTE:
If you hear the radio suddenly begin to emit a steady beep,
it means that the system voltage has dropped down to 6.6 volts.
Land as soon as the runway is clear so you can switch the radio
off and recharge its battery.
(See the battery charging sidebar on page 6)
"EDIT" buttons
This pair of buttons has three basic functions: they get you into
the
initial setup menu when you hold both EDIT buttons down
and then turn on the radio; they get you into the model setup menu
when you push both down when the radio is already on;
and once you are in either of these menus pushing one button
scrolls you up or down through the list of menu items.
"DATA" buttons
As the "+" and "-" symbols imply, these buttons allow you to change
a numerical value (most often a % value of servo travel) up or down
within a menu item. When not in the programming mode either of
these buttons enable the countdown timer.
"LOCK" button
This button is primarily a safety feature for powered models:
When you push this button down the throttle channel on the model
is taken off-line so that an accidental movement of the throttle stick
won't change the setting. Get in the habit of using this function
whenever you are carrying your model to the flight line.
SAFETY NOTE:
KEEP YOUR HANDS AWAY FROM THE PROPELLER OR
ROTORS EVEN AFTER ENABLING THE LOCK FUNCTION-A
RADIO GLITCH COULD STILL ACTIVATE THE THROTTLE !
"CLEAR" button
You can use the clear button whenever you want to reset a
numerical value to its starting point. It is also used in one of the
menu screens (the P MIX TRM) to turn a function on or off.
On-Off switch
This switch does more than just turn the radio on and off-it also
gets you into the initial setup programs when you hold down the two
"EDIT" buttons as you slide the switch from "off" to "on".
When you turn off the switch after making selections in the initial
setup menu , you "lock" your choices into the radio for this particular
model slot. The switch is coupled to the light located a couple of
inches above it-it comes on when the switch comes on and goes
off when the switch is turned
"CURSOR" buttons
When you are in a particular menu item, you'll use these
two buttons to scroll within it-most commonly to the right or left to
select a servo channel. When not in the programming mode,
these buttons start, stop and reset the radio's countdown timer.
EDIT
DATA
CURSOR
TIMER RESET
TIMER MODE
TIMER START
LOCK
CLEAR 6 CHANNEL DIGITAL PROPORTIONAL
FM RADIO CONTROL SYSTEM