IFM Ecomat 300 AC1421, Руководство по эксплуатации устройства

Страница: 272 / 365

272
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Appendix Fieldbus EtherNet/IP
>
General error codes
5682
Revision: 2014-03-05
Error Code
[hex]
Error Meaning
0x01 NOK no slave response OR:
master is in the offline mode when requesting the command
0x02 SND no slave with the old address found
0x03 SD0 slave with address 0 connected
0x04 SD2 slave with the new address already exists
0x05 DE error when deleting the old address
0x06 error when reading the IO configuration
0x07 SE error when writing the new address or extended ID code 1
0x08 AT new address could only be saved temporarily
0x09 ET extended ID code 1 could only be saved temporarily
0x0A NA the slave is not in the LAS
0x0B ID parameter or address invalid
0x0C faulty S-7.4 protocol sequence
0x0D ST S-7.4 protocol aborted (timeout)
0x0E IA invalid AS-i slave address for the S-7.4 protocol (e.g. B slaves)
0x0F SSA AS-i slave has aborted the S-7.4 string
0x10 AS-i S-7.4 no longer connected (no longer in LAS)
0x11 STA another S-7.4 transfer to the addressed AS-i slave is already active
0x12 HSE the previous segmented S-7.4 transfer was not yet completed
0x13 IDL invalid S-7.4 data length
0x14 master is in the wrong operating mode *)
0x16 timeout during command processing
0x17 CMD_PRE start requirements for S-7.4 command not met:
- wrong slave profile (is not S-7.4) or:
- slave is not in LAS or:
- master is not in the Protected mode
0x18 NM master is not in the protected mode
0x19 master is not in projection mode
0x20 command could not be processed within the specified time
0xE0...0xEF
CTT2 error detected by AS-i slave;

CTT2 error codes
(
→ page
273 )
0xF0 invalid CTT2 command
0xF1 invalid CTT2 response
0xF2 S-7.5 data length longer than 30 bytes