IEMCA VIP80E-II, Руководство по эксплуатации и техническому обслуживанию

Страница: 91 / 108

6 - USE AND OPERATION VIP80E-II
EN
6 - Pag. 11 / 14
6.9 LATHE SPINDLE LINER CHANGE
We recommend using a spindle liner in order to guide the bar correctly into the lathe. The
internal diameter of the liner must be at least a millimetre more than the external diameter of
the bar pusher bearings or the diameter of the bar to be machined (see table "Bar and bar
pusher diameters" paragraph 2.5.).
The replacement has to be made in the area between the lathe and the bar feeder. If equipped
with the shifting device (see paragraph 7.5.), remove the bar feeder. Otherwise proceed as
follows.
- Press the key (3) to select the manual mode.
- Press the start buttons (1) and at the same time
key (15) to lift the bar pusher;
- Press the button (12) to lower the guide channel.
8070_06_05_1
1
3
12
1