USE AND OPERATION
6
30
2.
0
2
8
- 38 -
6.2.
6.3.
BAR STOCK - CHARACTERISTICS AND
PREPARATION
The bar stocks must comply with the features shown in
the table.
DANGER - WARNING: The maximum stock length
must be contained within the lathe spindle length.
CAUTION: Do not feed bars having a different size than
that prescribed by the Manufacturer.
❏
Bars
– Bars should not have too much excess flash at their
fore end. This would affect their feeding into the
lathe collet.
❏
Tubes
– Tubes should not have too much excess flash at
their fore end. This would affect their feeding into
the lathe collet.
– Prepare a cap
to mount into the rear end of
the tube
B
in order to avoid that:
– the thrust of the bar pusher
C
is not transmitted to
the tube
B
.
– the lathe coolant flows out in the feeder.
Model
14
15
Min. bar diameter
ø 5 mm
Max. bar diameter
ø 80 mm
Min. bar length
250 mm
Max. bar length
1400 mm
1560 mm
28.056 Ec.2
B
A
C
•
•
•
Содержание VIP 80
