IEMCA SMART 316, Руководство по эксплуатации и техническому обслуживанию

Страница: 91 / 166

6 - USE AND OPERATION SMART316
EN
6 - Pag. 17 / 20
6.4.5 Cycle actuation mode in the STEP BY STEP function
Introduction
This mode can be used for many reasons, as for instance:
• To open the guide channels;
• to check a complete bar change cycle;
• to check the bar feeder mechanics;
• to load a single bar with the intent of checking the facing;
• et
cetera.
Procedure
1 Press to start the bar feeder.
• check that the guide channels of the bar feeder
are closed. If not, close the guide channels in
manual.
2 Press and to select the semiautomatic
mode;
3 press : the first step will be executed (bar
pusher return);
3 press : the second step will be executed, and so on.
6.5 FEEDER STOP
FEEDER EMERGENCY STOP
CAUTION:
if the emergency stop is used during lathe machining, before resuming work
make sure that the sudden stop has not created any hazardous condition (e.g., if
the tool was cutting chips, move the tool away from the workpiece before
restarting the lathe).
• To stop the feeder in an emergency, press an emergency push-button, either that of the
lathe or that of the feeder.
FEEDER STOP AT WORK END
CAUTION:
do not use emergency buttons for normal machine stop.
• Complete the operations in your work schedule.
Bar feeder waiting
AUTO or MANUAL?