IDX CW-F25, Инструкция по эксплуатации

Страница: 43 / 82

Useful information Troubleshooting
42

LCD backlight will light immediately after the power is turned ON. It will remain lit
during operation. If the LCD does not turn on while the CW-F25 is on, please contact
IDX Service or your local representative.
4) TX and RX does not link

Please check the LED status. A Solid Red LED indicates initialization of the system; a
Flashing Green LED indicates signal searching; a Solid Green LED indicates the system
has connected successfully. If the video signal is not transmitted even when the Green
LED is solid, please refer P.43 "No video out".

Please reboot the power if the status LED does not change to solid Green after one
minute. It is a system failure if this situation has not recovered after power reboot .

If Indoor DFS or Outdoor DFS is selected, the system automatically goes into a standby
state for about 1 minute (LED flashes Green). During the standby state, the CW-F25 is
searching for radar radio waves.

Please check if antennas are firmly connected. It may become loosen during operation.

Is the distance between transmitter and receiver too close?
When used with standard antennas, separate the TX and RX antennas by 3m.

Is the distance too far in between the antennas? Please re-try after reducing the distance.

Are there any radio-wave-shielding objects in between the antennas? Obstacles which
are made with concrete, metal and glass with electromagnetic shielding, will cause a
disturbance or blockage of radio waves.

Transmission path will be affected by the surrounding buildings, obstacles and
environment; therefore, there are places where radio waves are weak despite a short
distance.

Are 5GHz wireless LANs used in your neighborhood? Wireless LANs can co-exist with
other 5GHz wireless devices, but if frequencies overlap, interference or failed
connection may occur. Please try with a different frequency.

Is there a high power electromagnetic or microwave source nearby? Wireless
connections in this environment are weakened due to the reduced signal reception on
the receiving end. The reception can be weakened even if the high power RF source is
operating on a different frequency band. Please avoid using the CW-F25 in this type of
environment.

Is the SSID setting on the transmitter and receiver the same? The SSID must be the
same on the TX and RX to communicate. *Same SSID is set as factory default.

Is the password setting on the transmitter and receiver the same? The password must be
the same on the TX and RX to communicate. *Same password is set as factory default.