IDX CW-F25, Инструкция по эксплуатации

Страница: 42 / 82

Useful information Troubleshooting
41
IV. Useful information
1. Troubleshooting
Check the following before requesting for repair service. If the problem is not resolved,
please contact your dealer or our support & service team.
Please refer to P.78 "Support & Service contact".
1)
Power does not turn on

Check if the LED is emitting light. If it is lit or flashing, the power it turned ON. If the
LEDs are active, there is a possibility that the LCD backlight has failed.

Please make sure the input voltage is within specifications.
Voltage range of CW-F25 is DC7-17V.

Please check that the AC adaptor or power supply is turned ON.
Is the AC adapter connected to a commercial power source correctly?

Does the battery have sufficient capacity and output voltage?

Is the battery mounted to the P-V2CL correctly? The battery must be seated straight
down from the upper side of the V-Plate. Improper battery handling may damage the
pins on the V-Plate.

Is the polarity correct on the 4-pin Cannon connector?
Pin assignment of Cannon XLR-4 is: #1 = negative, #4 = positive.

Is the Cannon connector locked in place?
When installing the A-MT2V(CW), make sure the connection of both connectors are
firmly plugged in. When mounting, ensure that wires are not being pinched between the
A-MT2V(CW) and CW-F25.
2) Status LED does not lit

Please check the power supply. Refer P.41 "Power does not turn on".

Status LED starts to emit about 15 second after the power is turned ON. This time
delay is caused by the circuit initialization time; it is not a malfunction.
3) LCD backlight does not light

Please check the power supply. Refer P. 41 "Power does not turn on".