60
Color (YMC) Density:
To set color density. Please maximize YMC density as
you can, which enables to express range of color and vivid images. But If it
is too strong, green or red marks are appeared. orIf it is too weak, the print
quality will be dull.
Black(K) Density:
To set resin black density. In the picture, barcode is printed
to express density.
When density is too strong, barcode is printed too thick. When density is
too weak, barcode is too thin. Please adjust resin black density to express
clear barcode. Please refer to the following pictures.
Resin(X) Density:
To set the printing density for the resin (such as holograms)
panel. If the density is too strong, the resin panel looks a little blurry, as
shown on the Figure, and the ribbon folds and stripes appear. Also, if
density is too weak, the resin panel will not print as on the red line in right
figure. In order to check the untranscribed part, it's easy to see it if you look
at it obliquely in the light. Therefore, set the print density to be evenly
printed throughout the card by adjusting the print density
⑧
To print calibration card.
⑨
To show advanced set up.
(it is recommended not to set advanced setup.)
⑩
To load or save values.
Get Config.:
to get values from current printer.
Set Config.:
to set values to current printer.
Load from File:
to load values from file.
Save to File:
to save values to file.
Close:
to close CardPrinterConfig.
Содержание SMART-81
Страница 1: ...1 SMART 81 User Manual Retransfer Card Printer ...
Страница 38: ...38 2 4 Stacker Installation Install the card stacker Figure 26 Installation SMART 81 card stacker ...
Страница 89: ...89 3 After installing the filter press the protective cover in the direction of the arrow to close it ...
