Part 2 - Configuration
57
●
Min. Blocks
: Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under
Zone
for daytime and nighttime, each.
●
Etc
: Select Etc to detect an event on PTZ movement.
●
Actions
: Specify which actions to take when motion
is detected.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
●
Ignoring Interval
: The system does not produce
event log entries or issue remote notifications
regarding motion detected for the time specified
after the initial motion was detected. Set the value
between 1 sec and 5 secs or choose
Never
.
Ignoring Interval does not affect motion detection
recording.
●
Daytime Setup
: Specify when daytime starts and
ends. Adjust the time frame in 15-minute increments.
Times outside the specified range will be assumed as
nighttime by the system.
