Part 3 - Configuration
51
-
Reverse
: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
-
Select All
: Select all blocks.
-
Clear All
: Clear all block selections.
-
Reverse All
: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
-
Trip Direction
: Define in which direction
the motion has to occur in order for it to be
considered an event. Select In for movements
from outside the selection area in or Out for
movements from inside the selection area out.
-
OK
: Save the changes and exit the menu.
-
Cancel
: Exit the menu without saving the
changes.
•
Actions
: Specify which actions to take when Trip
Zone is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels and beeps.
-
Notify
: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
-
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
•
Trip Zone Ignoring Time
: The system does
not produce event log entries or issues remote
notifications regarding Trip Zone events detected
during the specified time following the initial Trip
Zone event. Set a value between 1 sec and 5 secs
or choose Never.
Trip Zone Ignoring Time does not affect Trip Zone
recording.
•
Daytime Setup
: Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specified range will
be assumed as nighttime by the system.
Tampering
•
No.
: Select which cameras to apply Tampering to.
•
Sensitivity
: Set to between 1 (Low) and 5 (High).
•
Activation Time
: Specify how long tampering
detection needs to last in order for it to be
considered an event. Tampering detections that do
not last for the specified duration of time will not be
considered as events.
•
Actions
: Specify which actions to take when
Tampering is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to
Event
or
Time & Event
mode,
the selected cameras will begin linked recording
when an event occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels and beeps.
-
Notify
: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
-
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
•
Use Ignoring Time
: Select
Time Setup
to specify
the tampering detection ignore time. Tampering
detection will be disabled during the specified time
frame.
