iDirect iQ LTE Series, Инструкция по установке, поддержке и обслуживанию

Страница: 33 / 70

Installation, Support, and Maintenance Guide 19
iQ LTE Satellite Router
Tools and Supplies Required for Installation
5. Prepare the Ethernet cable(s) and connector(s) as described in Section C.2, Ethernet Port
Pinouts on page 43 . For connection to the user interface, use ETH1 port with an RJ-45
cable as described in Section C.2.2, on page 44 .
6. If using the Console port for servicing, prepare the console port cable and connector as
described in Section C.3, Console Port Connection on page 45 .
7. Mount the router as directed in Section 4.5, Mounting the iQ LTE Satellite Router on
page 20 .
8. Connect the power as directed for either AC or DC power supplies:
•
See Section 4.5.1, Installing With an AC Power Supply (Option 1) on page 22
• See Section 4.5.2, Installing With a 36-76 VDC Power Supply (Option 2) on page 23
9. Monitor front and rear panels during startup. See Section 3.1, iQ LTE Satellite Router
Front LEDs on page 11 and Section 3.3, iQ LTE Satellite Router Rear Panel Descriptions on
page 15 .
10. Prepare PC for iQ LTE Satellite Router connection as specified in Section 4.6, Preparing
the PC for Connection to the iQ LTE Satellite Router on page 25 .
11. Login PC to the user interface.
12. Install the firmware and configure the satellite router as specified in Section 4.7,
Configuring the iQ LTE Satellite Router on page 25 .
13. If the router needs repacking or maintenance see Chapter 5, Maintenance on page 29 .
14. When the iQ LTE Device is physically installed, the firmware and configuration of the
satellite router needs to be completed. Refer to the
Terminal WUI User Guide for the
release of software installed on the system and for instructions.
4.2 Tools and Supplies Required for Installation
Appendix B, Tools Needed on page 37 specifies recommended tools and supplies used when
installing the iQ LTE Satellite Router.
4.3 Unpacking iDirect Equipment
The satellite router and related equipment may be shipped in one or more shipping
containers. Once all of the boxes have been received, perform the following tasks:
•
Confirm the boxes are facing upward (refer to the box orientation arrows on the shipping
container)
• Inspect all shipping containers
• If any damage or other signs of mishandling are evident, inform the carrier and either
iDirect or the reseller
• Remove the tape and any exterior covering from the box lid
Save the iQ LTE Satellite Router shipping boxes after unpacking the system. These boxes will
be needed in the event of moving or shipping the system in the future. See
Section 5.5,
Repacking the iQ LTE Satellite Router on page 32 for repacking information.