iDirect iQ LTE Series, Инструкция по установке, поддержке и обслуживанию

Страница: 39 / 70

Installation, Support, and Maintenance Guide 25
iQ LTE Satellite Router
Preparing the PC for Connection to the iQ LTE Satellite Router
4.6 Preparing the PC for Connection to the iQ LTE
Satellite Router
For more information on LEDs, see Section 3.1, iQ LTE Satellite Router Front LEDs on page 11 .
Confirm the PC:
•
Has a Web browser installed
• Has an IP address that is on the same subnet of the iQ LTE Satellite Router
• Includes a Network Interface Card (NIC) connected with a CAT 5 Ethernet cable
4.7 Configuring the iQ LTE Satellite Router
When the iQ LTE Satellite Router is physically installed, the downloading the firmware and
configuration of the satellite router need to be completed. For information on installing
software packages, see the
Terminal WUI User Guide . To download the guide, go to
https:\\support.idirect.net and click Satellite Routers .
4.8 Connecting a Cradlepoint LTE Device to the
Network
Cradlepoint devices are centrally configured and managed by a cloud-based system called
NetCloud Manager. Once devices are sold, they will be created in a customer account on the
NetCloud Manager. Key users will be given accounts that will enable them to configure and
manage devices on NetCloud Manager.
Once you have access to NetCloud Manager, you can start configuring your devices based on
your use case.
When devices are activated and can communicate with NetCloud (via the SIM or a WiFi
network or even satellite connection), they will load the configuration from the NetCloud.
You can also configure single devices locally by accessing the NCOS user interface. Changes
made using the NCOS user interface will be synced with the NetCloud Manager and vice versa.
It is highly recommended that you become familiar with the NetCloud system prior to
deployment.
There are multiple resources available online from the Cradlepoint knowledge base. See
Appendix F, Cradlepoint IBR900 and NetCloud Manager References for more information.
4.8.1 Connecting a Cradlepoint LTE Device to a Local Network
Connecting the Cradlepoint LTE Device to a local network does not require the SIM card
installation. Perform all steps describe in this section to connect the internal Cradlepoint LTE
Device to the local network via the Traffic Ethernet Port.
Step 1. Connecting to the Cradlepoint IBR locally via NCOS
1. Connect your PC to the iQ LTE traffic Eth port and open an Internet browser.
2. Enter the IP address of the Cradlepoint module.