iDirect iQ LTE Series, Инструкция по установке, поддержке и обслуживанию

Страница: 37 / 70

Installation, Support, and Maintenance Guide 23
iQ LTE Satellite Router
Mounting the iQ LTE Satellite Router
4.5.2 Installing With a 36-76 VDC Power Supply (Option 2)
For an iQ LTE Satellite Router using a 36-76 VDC power supply (Option 2):
1. First, perform steps 1-6 of the Installation Checklist, Section 4.1, on page 17 .
2. Set the iQ LTE Satellite Router power switch to the OFF position (0).
3. Prepare the power cables per the instructions in Appendix D, DC Power Supply
Installation on page 47 and connect the power cables.
4. Set the iQ LTE Satellite Router power switch to the ON position (1).
5. Upon powering up, a Level 0 Reset occurs. Reset options are available in Appendix E, iQ
LTE Satellite Router Reset on page 51.
6. Monitor front and rear panel lights during startup. See Section 3.1, iQ LTE Satellite
Router Front LEDs on page 11 .
7. Prepare PC for iQ LTE Satellite Router connection as specified in Section 4.6, Preparing
the PC for Connection to the iQ LTE Satellite Router on page 25 .
8. Login PC to the user interface. See Preparing the PC for Connection to the iQ LTE
Satellite Router .
9. Install the firmware and configure the satellite router as specified in Section 4.7,
Configuring the iQ LTE Satellite Router on page 25 .
4.5.3 Installing the SIM Card(s)
To install the SIM cards (not included with the hardware):
1. Ensure that the iQ LTE Satellite Router is unplugged.
2. Turn the iQ LTE router upside down.
3. Open the bottom cover panel and locate the SIM card module (see Figure 4-1 ).
Figure 4-1. SIM Card Module
CAUTION: The BUC power requirement must match the proper voltage. The
BUC may sustain damage if used with the incorrect power supply.