iDirect iQ LTE Series, Инструкция по установке, поддержке и обслуживанию

Страница: 36 / 70

22 Installation, Support, and Maintenance Guide
iQ LTE Satellite Router
Mounting the iQ LTE Satellite Router
4.5.1 Installing With an AC Power Supply (Option 1)
For an iQ LTE Satellite Router with an AC power supply Option 1, follow these steps:
1. First, perform steps 1-6 of the Installation Checklist, Section 4.1, on page 17 .
2. Connect the TX and RX coax cables to the iQ LTE Satellite Router and secure but do not
over-tighten. See
C.1, Coax Cable Preparation on page 39 for preparation details.
3. Connect LTE antenna
4. Connect GPS and WIFI (if present)
5. Connect the AC power cord to the power source. This will power ON the iQ LTE Satellite
Router.
6. Monitor the front and rear panel lights during power on startup. See Section 3.1, iQ LTE
Satellite Router Front LEDs on page 11 .
7. Prepare PC for iQ LTE Satellite Router connection as specified in Section 4.6, Preparing
the PC for Connection to the iQ LTE Satellite Router on page 25 .
8. Login PC to the user interface. See Preparing the PC for Connection to the iQ LTE
Satellite Router .
9. Install the firmware and configure the satellite router as specified in Section 4.7,
Configuring the iQ LTE Satellite Router on page 25 .
CAUTION: Direct connections to the power source should only be made by a
properly licensed electrician. Installation must meet applicable electrical codes.
CAUTION: Improper power source rating, excessive noise or transients, or
undersized circuit breaker will result in service interruption.
CAUTION: If power must be removed from the chassis, ensure the power cord is
disconnected first.
CAUTION: The BUC power requirement must match the proper voltage. The BUC
may sustain damage when used with incorrect power supply.
NOTE: Install an easily accessible socket-outlet near the equipment.